It’s usually the last thing on your mind, but you have to be clear thinking all the way to the end.

When you are packing up to leave the floor, be sure and have all of your boxes, crates, skids, bags and cartons accounted for and assigned to an outbound shipment. Read More...

At the recent NACStech show, my first task was laying cables for the in-booth network. While at first, this seems like an easy task, it can be complicated.

Trust me.

While I could just as easily had the cables lay down next to electrical cables, the CAT 5’s were needed in specific places. Several rules are to be applied in this process:

• Have a clear map of where cables are to go.
• Label each cable on each end (1A, 2B, et al).
• Run redundant cables in case of failure.
• Tape the cable flat to the floor so that are flat under the pad.
• Lay the pad directly over the cables. Notch if they are too bulky.
• Be sure and pull all cables through the pad and carpet as it is cut.
• Be sure and pass all cable ends through cabinet access holes.

If you do all of this beforehand, you are less likely to have to “fish” a cable after the carpet is laid or have a cable fail during the show. Read More...

The word from NACS (the National Association of Convenience Stores) is that their event in Texas will proceed.

After contacting show management on behalf of our client, Retalix, I learned that NACStech, set for May 18 to 21 at the Gaylord Texan Resort in Grapevine, Texas, will happen. Read More...